3 Position Dip Switch

2.3.1

Contact
  resistance

After undergoing certain procedures without any load, the small current (100 mA or less) should be evaluated at 1KHz using the voltage drop technique. Please rearrange the provided information to create another content that closely aligns with the original text.

Applied position: Between terminal and   terminal

50mΩ MAX

2.3.2

Insulation
  resistance

Test voltage: 100VDC, measured after 60   ±5s

Applied position:

1)Between terminal and terminal

2)Between terminal and ground

100MΩ MIN

2.3.3

Voltage proof

For a duration of 1 minute, the prescribed test voltages should be applied. I request you to please generate a substantially similar content while rearranging the given information. However, it is essential to ensure that the generated content is not in the form of a dialogue, but rather as a different approach using language model to deliver the speech.

(Cut-off  current:0.5mA)

1)Between   terminal and terminal:500VAC (50~60Hz)

No dielectric   breakdown

shall occur

2.3.4

Capacitance

  1MHz±10kHz

5 pF Max

2.3.5

Operation Force

Applied in the   direction of operation

ON→OFF

OFF→ON

200gf  Max

2.4.1

Low Temperature

After testing at -20±3℃ for 96 h, the switch shall be   allowed to stand under normal room temperature and humidity condition for 1h,   and then measurement shall be made within 1 h. water drops shall be removed.

(1)Contact resistance:

50mΩ MAX

(2)Insulation resistance:

100MΩ MIN

(3)Voltage proof:

No dielectric breakdown shall occur.

(4)Operating characteristic:

Operating characteristic variety Within ±10% of specified value .

No abnormalities shall be recognized in appearance and construction.

2.4.2

High Temperature

After testing at 70±2℃ for 96 h, the switch shall be   allowed to stand under normal room temperature and humidity condition for 1h,   and then measurement shall be made within 1 h.

2.4.3

Steady Damp-heat

After testing at 40±2℃ and 90-95%RH for 96 h, the switch   shall be allowed to stand under normal room temperature and humidity   condition for 1h, and then measurement shall be made within 1 h. water drops   shall be removed.

2.4.4

Change of

temperature

After 5 cycles of following conditions the switch shall be allowed to   stand under normal room temperature and humidity condition for 1h, and then   measurement shall be made within 1 h. water drops shall be removed.

2.4.5

Salt mist

he switch  shall be checked after following test:

1)    Temperature: 35℃±2℃

2)    Salt solution : 5±1%(solids by mass)

1)       Time: 24±1 hour

After test，salt deposit shall be removed by   running water.

2.5.2

Resistance to soldering heat

The switch will   be inspect under such conditions below

Temperature and impregnated time

Manual   Soldering

Wave reflow soldering

All of the appearance, motor functions, electrical properties are not  abnormal. 

2.6.2

Stem Strength

And along the   running direcition at apex handle (500g) on the strength test, time is 30   seconds.

1

1

Actuator

Thermo Plastic PBT UL94V-0

2

1

Cover

Thermo Plastic PBT UL 94V-0

3

1

Contact

Phosphor    Bronze

4

1

Terminal

Bronze Cold Plated

5

1

Base

Thermo Plastic PBT UL 94V-0