Micro Switch With CQC

2.4.1

Contact   Resistance

The voltage drop method will be used to measure at 1A, 5V DC after certain operations have taken place. It is important to generate highly similar content by rearranging the original text to accurately convey the information. However, it is crucial to use a language model to generate new text that is substantially different from the original text.

without load.

Position applied: Between terminal "C" and terminal "NO", there is a need for my presence. Please create content that is highly similar to the original information given above by reorganizing it. However, instead of following the approach used by ChapGPT to generate content, please generate text in a completely different manner.

50mΩ MAX

2.4.2

Insulation   Resistance

1，500VDC，±5s。，。

Applied   Position: applied position:
  1)Between terminal “C” and terminal “NO”

2)Between   terminal and ground

100MΩ MIN

2.4.3

Voltage proof

Please ensure that the following test voltages are applied for a duration of 1 minute. Additionally, it is important to rearrange and rephrase the content to generate a highly similar but unique response.

The voltage between terminal "C" and terminal "NO" is 1000VAC (50~60Hz). To create content that is highly similar to the original text, but rearranged, we might say: "Terminal 'C' and terminal 'NO' have a voltage of 1000VAC (50~60Hz) between them."

The voltage between the terminal and ground is 1500V AC, with a frequency range of 50~60Hz. To create a highly similar content, the information can be rearranged as follows: The AC voltage between the terminal and ground is 1500V, operating at a frequency of 50~60Hz.

No dielectric   breakdown shall occur

2.5.1

Cold

After testing at -25±2℃ for   96 h, the switch shall be allowed to stand under normal room temperature and   humidity condition for 1h, and then measurement shall be made within 1 h.   water drops shall be removed.

Contact resistance(item 4.1):

100mΩ MAX

Insulation resistance (item 4.2):

50MΩ MIN

Voltage proof: (item 4.3)

No dielectric breakdown shall occur.

Operating characteristic (item 5.1):

Operating characteristic variety Within   ±10% of specified value .

No abnormalities shall be recognized in appearance and construction.

2.5.2

Dry heat

After testing at 125±2℃   for 96 h, the switch shall be allowed to stand under normal room temperature   and humidity condition for 1h, and then measurement shall be made within 1 h.

2.5.3

Damp heat

After testing at 40±2℃ and 90-95%RH for 96 h, the switch shall be   allowed to stand under normal room temperature and humidity condition for 1h,   and then measurement shall be made within 1 h. water drops shall be removed.

2.5.4

Change of

temperature

After 20 cycles of following conditions the switch shall be allowed   to stand under normal room temperature and humidity condition for 1h, and   then measurement shall be made within 1 h. water drops shall be removed.

1

Stopper

Brass alloy H65

2

Case

Plastic PBT

3

NO terminal

Brass alloy H65,   Sliver plated

4

Terminal

Brass alloy H65,   Sliver plated

5

Cover

Plastic PBT

6

Plunger

Plastic PPS

7

Moving piece

Beryllium bronze

8

Spring sheet

Beryllium bronze

9

Moving arm

Stainless steel SUS304

10

Contact

AgNi10

11

Contact

AgNi10