Rocker Switch Gang Waterproof

2.3 Operating Characteristics: Note: Actuating Force: To move the actuator from its free position, a certain amount of force is necessary. This force will depend on various factors such as the type of actuator, its size, and its overall design. It is important to ensure that the force applied is...

2.3 Operating Characteristics:

Characteristics	Units	Standards	Note
Actuating Force	N	5±3 Max	Original 5±3. .
Contact Force	N	0.4 Min	Original 0.4 Min
Electrical Clearance	mm	3 Min	Original 3 Min

Note:

Actuating Force:

To move the actuator from its free position, a certain amount of force is necessary. This force will depend on various factors such as the type of actuator, its size, and its overall design. It is important to ensure that the force applied is sufficient to move the actuator smoothly and without causing any damage. Additionally, it is crucial to consider the environment in which the actuator is being used as this may also affect the force requirements. By carefully considering these factors, it is possible to ensure that the actuator operates effectively and efficiently in the desired application.
the operation position

2.4 Electrical Specification:

NO.	Items	Test conditions	Requirements
2.4.1	Contact Resistance	Shall be measured at 50VAC by voltage drop method after some operations without load. Applied position: Between terminal and terminal	30mΩ MAX
2.4.2	Insulation Resistance	Test voltage:500VDC, measured after 1 min ±5s Applied position: 1)Between terminal and terminal 2)Between terminal and ground	100MΩ MIN
2.4.3	Voltage proof	Following test voltages shall be applied for 1 min. (Cut-off current:0.5mA) 1)Between terminal and terminal : 1500VAC (50~60Hz)	No dielectric breakdown shall occur

2.5 Welding Characteristics:

2.5.1

Solder ability

Switch test under such conditions and inspect after.

1）Variable temperature range ：235±5℃；

2）Dip time：3±0.5s；

The area of dip tin should capture the 95% impregnated area

2.5.2

Resistance to soldering heat

The switch will be inspect under such conditions below

Temperature and impregnated time

Trial measuretemperature（℃）Time（s）Slot welding method260±55±1Soldering method350±53±0.5

All of the appearance, motor functions, electrical properties are no abnormal.

3. Drawing & Dimension:

4. Circuiy Diagram:

6.Remarks

PARTS LIST:

ITEM	NAME	MATERIAL
1	Base	Plastic
2	Button	Plastic
3	Terminal	Brass alloy H65,Tin Plated
4	Moving piece	Brass alloy H65,Silver Plated
5	Spring	Carbon spring steel thread,nickel plated
6	Light	Neon lamp-Red

Returned plastic should not exceed 20%.

7.Delivery,shipping and service

TO6(0NMP4F[DWUIG7[DR~YI

Hot Tags: rocker switch gang waterproof, China rocker switch gang waterproof manufacturers, suppliers, factory